Marble Magik Corporation

Magik Flex

Magik Flex

Product Code: 5150 Categories: ,

Multipurpose two-component polyurethane thin-set adhesive for fixing tiles & stones on interior and exterior floor and wall. Designed especially for interior and exterior floor and wall installation of all types of ceramic tiles, vitrified tiles, semi-vitrified tiles, engineered stone, stone, and tile over concrete and on a variety of subtracts including metal subtracts and dry wall boards. 

Part A: Resin

Part B: Hardner


  • Two-component, just mix and use
  • High strength chemical resistance • Economical
  •  Easy to use
  •  Water, freezing, thermal shock resistance
  •  Flexible and heat resistance
  •  Compiles to EN/ISO with R2T classification
  • Concrete
  • Vacuum dewatered flooring
  • Tremix
  •  Metal floor and wall
  • All types of tiles and stones
  • All types of wood and plywood
  • Epoxy or PU resin-based subtracts


Part A – Paste
Part B – Paste


Part A – Light Grey
Part B – Light Grey

Pack Size:

5 kg
Part A: 4.35 kg
Part B: 0.65 kg



    TDS Magik Flex 5150

    Magik Flex is prepared by mixing together parts A and B from the bottom upwards, using a low-rev (≈ 400/min.) helicoidal agitator, with the preset ratio of 1:7 of the packs. Pour part A into the bucket containing part B, being careful to mix the two parts uniformly until a smooth, even coloured mixture is obtained. The user must mix a quantity of adhesive which can be consumed within 1 hour at +25 °C.

    Application Process

    Apply adhesive to the substrate with the flat side ofthe trowel, pressing firmly to work into the surface. Comb on additional adhesive with the notched side.
    Use the proper sized notched trowel to ensure full bedding of the tile. Spread as much adhesive as can be covered with tile in 10 minutes. Back butter large format tiles (> 12”x12”) to provide full bedding and firm support. Place tiles into wet, sticky adhesive and beat in using a beating block and rubber mallet to
    imbed tile and adjust level. Check adhesive for complete coverage by periodically removing a tile and inspecting bedding adhesive transfer onto back of tile. If adhesive is skinned over (not sticky), remove and
    replace with fresh adhesive.